Hi there
Just about to begin feasibility on developing 2x725sqm blocks (side by side) into townhouses and wondering what the difference between using an architect or a draftsperson to do the plans might be? I'm not sure why you would go with an architect (more expensive?) than a draftsperson - is it only for build design quality or are there other reasons?
I was searching for a thread that might explain the development process, but couldn't find one that talks specifically about the process, could someone please point me to a thread if they can think of one as I turned up multiple results that weren't quite what I was looking for.
Looking forward to being able to write a new post at some stage around the development
thanks
jerkygirl
Just about to begin feasibility on developing 2x725sqm blocks (side by side) into townhouses and wondering what the difference between using an architect or a draftsperson to do the plans might be? I'm not sure why you would go with an architect (more expensive?) than a draftsperson - is it only for build design quality or are there other reasons?
I was searching for a thread that might explain the development process, but couldn't find one that talks specifically about the process, could someone please point me to a thread if they can think of one as I turned up multiple results that weren't quite what I was looking for.
Looking forward to being able to write a new post at some stage around the development
thanks
jerkygirl